Pay attention to the 5 major problems of floor covering.

1. The reason for the sound of the drum sound is due to the fact that the fixing is not true, mainly because the number of nails and keels, the board and the floor nails are small or the nails are not strong, and sometimes the shrinkage or the glue is unqualified due to the change of the moisture content of the board. To. Therefore, the process of strictly testing the moisture content of the board, the quality of the adhesive, etc. is particularly important. It can only be used after passing the test. The nail should not be too small during installation.

2. The main cause of uneven surface is the unevenness of the base layer or the deformation of the floor strip. During the construction, apply the level to level the surface of the keel, if it is not flat, adjust the slab. Ventilation slots should be made on the keel. A 10 mm ventilation gap should be left at the edge of the board. The insulation layer material must be dry to prevent the board from getting up after damp. The flatness error of the wooden floor surface should be within 1 mm.

3. The reason for the lack of strict seams is not only the installation in the construction is not standardized, the width error of the sheet is large and the processing quality is also an important reason.

4. The main reason for the local warping drum is that the board is too small or seamless, and the water pipe is leaking and dampening the wet floor. After the floor is paved, the floor paint should be painted completely. In daily use, it is necessary to prevent water from flowing into the lower part of the floor. It is necessary to clean the surface layer of water in time.

5. The floor should use environmental protection tools during the cutting process to avoid the hazards caused by harmful wood chips, dust and formaldehyde.

Having two types of Electric Pile Driver need showing to you. One is GSH-30E, which voltage is 230V, Max.current is 9A, Max.power is 2000W, frequency is 50-60hz, no-load speed is 12/6 r/min, Max.toque is 3600 N.m and main body weight is 37.48kg and it can install 76x1800mm of Ground Screws and smaller. Another is GSH-50E, which voltage is 230V, Max.current is 18A, Max.power is 4000W, frequency is 50-60HZ, no load speed is 11/5 R/min, Max. Torque is 4800N.m and main body weight is 59.52kg and it can install 114x2500mm of Ground Screw Piles. Both electric Pile Driver are very high quality and exquisite.

Electric Pile Driver

Electric Pile Drivers, Ground Screw Machine, Electric Ground Screw Machine

Hebei Honde Industrial Trade Imp&Exp Co., Ltd. , http://www.groundscrewpile.com