Predecessors Super Practical Summary 31
1. The ground keel is best dried larch.
2. After the large wooden plate is bought, it must be sawn and dried.
3. Woodworkers approach the house first to play the horizontal line.
4. As soon as the color panel comes in, you will need to buy a paint brush again to prevent it from being contaminated.
5. Ceiling fans cannot be mounted on ceiling keels.
6. The color panel must be pre-selected during construction.
7. The ceiling of the suspended ceiling must not be more than 300 cm from the wall.
8. The gypsum board should be fixed with a countersunk head tapping screw, enter the surface of the board 1 mm to 2 mm, and do anti-rust treatment, can not use guns.
9. The distance between the plasterboard nails must not exceed 200 cm.
10. The gypsum board has a 3 mm gap with the wall for crack prevention.
11. Gypsum board is best done at the sun corner protection.
12. Up and down the wooden door to paint the head.
13. The bottom of the bathroom door cover should be brushed and waterproofed.
14. The size of the door should be the same.
15. Try not to let the carpentry do furniture, do not do well.
16. Cabinets try to buy the whole, carpentry does not work well, and the design does not work.
17. All kinds of dimensions must be considered well, it is more troublesome to change it.
18. Don't do dark tracks with your own sliding doors. There is no way to repair them later.
19. If the bathroom is small, try to make a sliding door, do not open the door and take up the place.
20. There must be more exchanges with the foremen than the woodworking that is not allowed. Do not allow them to make their own claims.
twenty one. Money is the hard truth in your hands.
twenty two. There are children at home, and glass is used as little as possible.
twenty three. Workers must be allowed to read the drawings.
twenty four. Kitchen drawers are useful.
25. Floor wood keel flatness is 5 mm.
26. The wool floor should be laid 30 or 45 degrees, leaving 2 mm to 3 mm between the board and the board. Stitches must be staggered.
27. Leave 8 mm to 10 mm of seam between the floor and the wall.
28. The expansion joints should be considered when the length of the composite floor exceeds 8 meters.
29. Minimize the use of MDF for door covers.
30. Hinges and hardware must be used well.
31. The Yuba should be mounted on a wooden keel and it cannot be mounted directly on a suspended ceiling.
Decoration Carpentry Knowledge Nature Flooring Flooring Paint Glass Doors Furniture Glass Doors Drawers Cabinets Doors Kitchen Cabinets Doors Glass Furniture Doors Glass Doors Kitchen Glass Sliding Doors Bathroom Doors Bathroom Doors Bathroom Size Bathroom WC Ceiling Monolithic Bathroom Toilet Design Toilet Waterproof Toilet Moving door
Thermal Mass Flowmeter,Thermal Flow Meter,Thermal Gas Flow Meter,Thermal Dispersion Flow Meter
Wuxi Winsun Automation Instrument Co., Ltd , https://www.jswxwinsun.com