Industrial floor maintenance
Industrial floor paint is a high-value, high-quality, high-demand product. The correct method of use can keep the ground as new and can be used for a long period of time. The specific recommendations are as follows:
Reference suggestion one
1. After the construction of the floor paint is completed, it needs to be maintained for 7-10 days before it can be put into use. During the curing period, water or other solution should be avoided to infiltrate the surface.
2. Any employee who enters the workshop must be replaced with a rubber-soled shoe (no black-soled shoes with a foam bottom) (to avoid the sand from the outside being scratched into the workshop)
3. Any hardware: such as iron chairs, iron tables, iron shelves, etc., should be wrapped with soft plastic, rubber or paper pad to avoid scratching the ground during use.
4, the tractor needs to fully lift the board off the ground, please pay special attention to the corner of the board when cornering, do not scratch the ground
5, when cleaning the ground, please use a soft absorbent or a wet and dry vacuum cleaner, can be cleaned with water or detergent, but please pay attention to the ground slippery
6. If it is worn or scratched due to long use time, local repair can be carried out in a small area. If the area is large, it is recommended to re-roll once.
7. Before the equipment enters the factory, lay the bottom of the cardboard box on the floor to avoid scratching the ground during transportation.
8, the cart, the wheel of the cart, please use hard or elastic rubber wheel, and use separately inside and outside the plant
9, can be waxed according to the ground requirements (the effect can prevent ground scratches)
Reference recommendation two
1. Under the condition of construction and production, the construction environment should have sufficient isolation zone to prevent ash, sand and the like from infiltrating into the unpainted paint film epoxy floor.
2. Areas that are easily contaminated, and more conspicuous parts of the facade, should be cleaned 1-2 times a day with a wide cloth mop.
3. If there are coarse and hard sand particles on the ground, the mud should be cleaned in time to prevent the sand from grinding the ground and reduce the wear on the ground.
4. Employees should change soft-soled shoes before entering the clean area; set up plastic blankets at the junctions and entrances where sand and mud are easily brought in, so that employees can remove the sundries when entering and leaving.
5. When the forklift and forklift unload the cargo, pay attention to the flattening of the cargo, and avoid the side of the cargo, dragging and scratching the ground.
6. Try to avoid braking when running on vehicles, forklifts and forklifts.
7. Frequent oil leakage and oil leakage, often cleaned with sawdust to avoid oil denaturation, adsorption of ash layer, and become intractable stains. In areas with large areas of oil immersion, a wide cloth mop can be used to push the sawdust to absorb the floor oil.
8. Machine tools should try to avoid falling off the ground.
9. If there is a large paint film damage, repair it in time to repair the oil before it penetrates into the foundation. When the workshop flushes the floor with water, avoid depositing the oil-water mixture in deep breakage.
The Small Peristaltic Pump with a simple and compact structure design that is suitable for the space-limited application, easy installation panel support customization depends on your work condition that easy to install into your equipment.
The Small Peristaltic Pump also with good working performance, suitable for interval working situations. Such as the sampler pump and discharger pump. widely used in various liquid processing equipment/instruments. Ideal solution for various liquid transfer applications.
Small Peristaltic Pump,Small Oem Pump,Chemical Transfer Pump,Laundry Detergent Pump
Baoding Chuangrui Precision Pump Co., Ltd. , https://www.crprecisionpumps.com